Popular Articles
"DR Signal Off" Alarm (Often Alarm 086 on a Fanuc)
This alarm occurs when the CNC checks the data ready handshake line (sometimes called DR or DTR) and finds that the device is not ready. There are a few possibilities for this problem depending on how your cables are wired. Verify that your port is ...
Cable Diagrams and Descriptions with Pinouts
Pinout 1: No Handshake Jumper? DB-9 PC (Female) Wire DB-25 CNC (Male) Jumper? (Disconnected) Shield 1 2 (Receive Data) Green 2 (Transmit Data) 3 (Transmit Data) Red 3 (Receive Data) 5 (Signal Ground) Black 7 (Signal Ground) 4 (RTS) 5 (CTS) JUMPER 6 ...
Mazak M32 Configuration Document
CNC Parameters G1 = 2 (CMT 4800 baud) G19 - 2 (EIA 4800 baud) G20 - 3 (2 stop bits) G21 - 0 (even parity) G22 - 0 (Disable parity check) G23 - 3 (8 data bits) G27 - 0 (CR/LF) G29 - 3 (XON/XOFF) G30 - 1 (No DC Code parity check) G40 - 0 (No DC2/DC4) ...
Fanuc Part Count
Determining part counts for Fanuc machines Standard Machines (not looping the program) Fanuc machines will either part count on M30/M02 or a custom M code specified. To enable the machine to count on and M30/M02 parameter 6700#0(PCM) must be 0. If ...
Fanuc 10T Configuration Document
CNC Parameters Setting screen: Punch code- 1=ISO TV CHECK=0 OFF Under Service page: 0000 = xxx01000 (ISO) 0020 = 2 (Input device Foreground) 0021 = 2 (Output device Foreground) 0022 = 2 (Input device Background) 0023 = 2 (Output device Background) ...