CNC Parameters

You will need to verify all parameters listed below that correspond to your CNC control.  These parameters may not match your particular machine’s control.  Document (Phone camera) original settings before making modifications!

Put machine into Edit mode

Select List

Select I/O

Select 232C Set

Input/Output Destination:  IC-CARD-R/W

Device Name:  IC-CARD-R/W

Baud Rate:  9600

Stop Bit:  2

Parity:  None  (does not match Factorywiz setting)

Char Length:  8 Bits  (does not match Factorywiz setting)

HRDWRE Flow:  Invalid

XO/XOFF:  Valid

DC Code Out:  Output (DC3 out)

TV Check:  OFF

EOB Output:  LF

Feed No.:  10

Time-Out:  30   (1/10 seconds = 3 seconds)

Data Code:  ISO

DC3 Code:  0x93

FactoryWiz DNC Settings

Basic Communication

1.01- Port Type: Standard

1.11- Baud: 9600

1.12- Data Bits: 7

1.13- ASCII Even

1.14- Stop Bits: 2

1.15- Handshake: XON/XOFF

Sending Options

2.11- Leader: %<10>

2.12- Trailer: %

2.23- Skip lines that contain: %

2.31- Automatic timeout: 7

Receiving Options

3.11- Program identifier 1: O

3.12- Program Identifier 2: :

3.21- Receive timeout: 3

3.31- Ignore data before first end-of-block: True

3.32- Ignore data after last end-of-block: True

Remote Commands

4.02- Request for file command: GET-

4.03- Request for file command (drip feed): DNC-

4:11- Request to save command: PUT-

Outputting CNC Programs:

Put machine into Edit mode, with Edit Protect key in the Enable position.

Select List

Select I/O

Select RS232C

Select OUTPUT

Type in Program number, then press INPUT.

Press INPUT again to start the output.

Inputting CNC Programs

Put machine into Edit mode, with Edit Protect key in the Enable position.

Select List

Select I/O

Select RS232C

Select INPUT.

Press INPUT.

Press INPUT again to start loading the program.

Wiring Diagram

Pinout includes RTS/CTS Handshaking